Endress+Hauser Proline Prosonic Flow 93 - Commissioning, Configuration of the BUS Interface

PROline Prosonic Flow 93 FOUNDATION Fieldbus 2 Resource Block
Endress+Hauser 93
DD_REV read only Displays the revision number of the device description.
 Note!
This display can be used to check whether the correct system files
(DD = Device Description) are being used for linking into the host
system.
The system files can be downloaded free of charge from the
Internet, (www.endress.com).
Example:
DD_REV parameter displays
→ 01
DEV_REV parameter displays
→ 01
Device description (DD) files required
→ 0101.sym and 0101.ffo
DEV_REV read only Displays the revision number of the device.
 Note!
This display can be used to check whether the correct system files
(DD = Device Description) are being used for linking into the host
system.
The system files can be downloaded free of charge from the
Internet, (www.endress.com).
Example:
DD_REV parameter displays
→ 01
DEV_REV parameter displays
→ 01
Device description (DD) files required
→ 0101.sym and 0101.ffo
DEV_TYPE read only Displays the device type in decimal numerical format.
Display:
4158 (1059 hex) for Prosonic Flow 93 FOUNDATION Fieldbus
FAULT_STATE read only Current status display of the security behaviour of the Discrete
Output function block.
Display:
UNINITIALIZED
CLEAR (security behaviour not active)
ACTIVE (security behaviour active)
FEATURES read only Displays the additional options supported by the device.
Display:
REPORTS
Event report is sent.
FAULTSTATE
The security behaviour of the Discrete Output function block is
supported, (see CLR_FSTATE and SET_FSTATE parameters).
HARD W LOCK
Hardware write protection
Resource Block / base index 258
Parameter Write access with
operating mode
(MODE_BLK)
Description