Endress+Hauser Proline Prosonic Flow W 400 - Page 108

Commissioning Proline Prosonic Flow W 400 HART
108 Endress+Hauser
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
entry
Factory setting
Format display A local display is provided. Select how measured values
are shown on the display.
• 1 value, max. size
• 1 bargraph + 1
value
• 2 values
• 1 value large + 2
values
• 4 values
1 value, max. size
Value 1 display A local display is provided. Select the measured value that
is shown on the local display.
• Volume flow
• Mass flow
• Flow velocity
• Sound velocity
• Temperature
• Density
• Electronics
temperature
• Signal strength
*
• Signal to noise
ratio
*
• Acceptance rate
*
• Turbulence
*
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Current output 1
Volume flow
0% bargraph value 1 A local display is provided. Enter 0 % value for bar graph
display.
Signed floating-point
number
Country-specific
100% bargraph value 1 A local display is provided. Enter 100 % value for bar
graph display.
Signed floating-point
number
Depends on country
and nominal
diameter
Decimal places 1 A measured value is specified
in the Value 1 display
parameter.
Select the number of decimal
places for the display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx
Value 2 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
Value 1 display
parameter
(→  101)
For the picklist, see
Value 1 display
parameter
(→  101)
–
Decimal places 2 A measured value is specified
in the Value 2 display
parameter.
Select the number of decimal
places for the display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
–
Value 3 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
Value 1 display
parameter
(→  101)
–
0% bargraph value 3 A selection was made in the
Value 3 display parameter.
Enter 0 % value for bar graph
display.
Signed floating-point
number
Country-specific
100% bargraph value 3 A selection was made in the
Value 3 display parameter.
Enter 100 % value for bar
graph display.
Signed floating-point
number
–