Endress+Hauser Proline Prosonic Flow W 400 - Configuring the Low Flow Cut off

Commissioning Proline Prosonic Flow W 400 HART
102 Endress+Hauser
Parameter Prerequisite Description Selection / User
entry
Factory setting
Value 3 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
Value 1 display
parameter
(→  101)
–
0% bargraph value 3 A selection was made in the
Value 3 display parameter.
Enter 0 % value for bar graph
display.
Signed floating-point
number
Country-specific
100% bargraph value 3 A selection was made in the
Value 3 display parameter.
Enter 100 % value for bar
graph display.
Signed floating-point
number
–
Value 4 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
Value 1 display
parameter
(→  101)
–
Value 5 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
Value 1 display
parameter
(→  101)
–
Value 6 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
Value 1 display
parameter
(→  101)
–
Value 7 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
Value 1 display
parameter
(→  101)
–
Value 8 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
Value 1 display
parameter
(→  101)
–
* Visibility depends on order options or device settings
10.4.9 Configuring the low flow cut off
The Low flow cut off wizard systematically guides the user through all the parameters
that must be set to configure low flow cut off.
Structure of the wizard
Volume flow
Assign variable
Off value
End of wizard
Off
On value
Mass flow Flow velocity
A0043342-EN
 50 "Low flow cutoff" wizard in the "Setup" menu