Endress+Hauser Proline Prosonic Flow W 400 - WLAN Configuration

Proline Prosonic Flow W 400 HART Commissioning
Endress+Hauser 109
Parameter Prerequisite Description Selection / User
entry
Factory setting
Decimal places 3 A measured value is specified
in the Value 3 display
parameter.
Select the number of decimal
places for the display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
–
Value 4 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
Value 1 display
parameter
(→  101)
–
Decimal places 4 A measured value is specified
in the Value 4 display
parameter.
Select the number of decimal
places for the display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
–
Display language A local display is provided. Set display language. • English
• Deutsch
• Français
• Español
• Italiano
• Nederlands
• Portuguesa
• Polski
• русский язык
(Russian)
• Svenska
• Türkçe
• 中文 (Chinese)
• 日本語 (Japanese)
• 한국어 (Korean)
• tiếng Việt
(Vietnamese)
*
• čeština (Czech)
English
(alternatively, the
ordered language is
preset in the device)
Display interval A local display is provided. Set time measured values are
shown on display if display
alternates between values.
1 to 10 s –
Display damping A local display is provided. Set display reaction time to
fluctuations in the measured
value.
0.0 to 999.9 s –
Header A local display is provided. Select header contents on local
display.
• Device tag
• Free text
–
Header text The Free text option is
selected in the Header
parameter.
Enter display header text. Max. 12 characters,
such as letters,
numbers or special
characters (e.g. @,
%, /)
–
Separator A local display is provided. Select decimal separator for
displaying numerical values.
• . (point)
• , (comma)
. (point)
Backlight A local display is provided. Switch the local display
backlight on and off.
• Disable
• Enable
–
* Visibility depends on order options or device settings
10.5.5 WLAN configuration
The WLAN Settings submenu guides the user systematically through all the parameters
that have to be set for the WLAN configuration.