Endress+Hauser Proline Prosonic Flow W 400 - Output Values

Operation Proline Prosonic Flow W 400 HART
122 Endress+Hauser
Navigation
"Diagnostics" menu → Measured values → Input values
‣
Input values
Value status input
→  122
Parameter overview with brief description
Parameter Prerequisite Description User interface
Value status input For the following order code:
"Output; input", option I "4-20mA HART,
2x pul./freq./switch output; status
input"
Shows the current input signal level. • High
• Low
11.4.4 Output values
The Output values submenu contains all the parameters needed to display the current
measured values for every output.
The parameters displayed depend on:
• The selected device order
• The set operating mode of the pulse/frequency/switch outputs
Navigation
"Diagnostics" menu → Measured values → Output values
‣
Output values
Output current
→  123
Measured current
→  123
Pulse output
→  123
Output frequency
→  123
Switch state
→  123
Output frequency
→  123
Pulse output
→  123
Switch state
→  123