Proline Prosonic Flow W 400 HART Technical data
Endress+Hauser 171
Heartbeat Verification
Meets the requirement for traceable verification to DIN ISO 9001:2008 Chapter 7.6 a)
"Control of monitoring and measuring equipment".
• Functional testing in the installed state without interrupting the process.
• Traceable verification results on request, including a report.
• Simple testing process via local operation or other operating interfaces.
• Clear measuring point assessment (pass/fail) with high test coverage within the
framework of manufacturer specifications.
• Extension of calibration intervals according to operator's risk assessment.
Heartbeat Monitoring
Continuously supplies data, which are characteristic of the measuring principle, to an
external condition monitoring system for the purpose of preventive maintenance or
process analysis. These data enable the operator to:
• Draw conclusions - using these data and other information - about the impact the
measuring application has on the measuring performance over time.
• Schedule servicing in time.
• Monitor the process or product quality, e.g. gas pockets .
For detailed information, see the Special Documentation for the device.
16.14 Accessories
Overview of accessories available to order → 151
16.15 Supplemental documentation
For an overview of the scope of the associated Technical Documentation, refer to the
following:
• Device Viewer (www.endress.com/deviceviewer): Enter the serial number from the
nameplate
• Endress+Hauser Operations app: Enter serial number from nameplate or scan
matrix code on nameplate.
Standard documentation Brief operating instructions
Brief Operating Instructions for the sensor
Measuring device Documentation code
Proline Prosonic Flow W KA01512D
Brief operating instructions for transmitter
Measuring device
Documentation code
HART Modbus RS485
Proline 400 KA01510D KA01660D
Technical Information
Measuring device Documentation code
Prosonic Flow W 400 TI01568D
To Next Page
Loading...
