Endress+Hauser Proline Prosonic Flow W 400 - Configuring the Measuring Point

Commissioning Proline Prosonic Flow W 400 HART
86 Endress+Hauser
Parameter overview with brief description
Parameter Description Selection Factory setting
Volume flow unit Select volume flow unit.
Result
The selected unit applies to:
• Output
• Low flow cut off
• Simulation process variable
Unit choose list Country-specific:
• m³/h
• ft³/min
Volume unit Select volume unit. Unit choose list Country-specific:
• m³
• ft³
Mass flow unit Select mass flow unit.
Result
The selected unit applies to:
• Output
• Low flow cut off
• Simulation process variable
Unit choose list Country-specific:
• kg/h
• lb/min
Mass unit Select mass unit. Unit choose list Country-specific:
• kg
• lb
Velocity unit Select velocity unit.
Effect
The selected unit applies to:
• Flow velocity
• Sound velocity
Unit choose list Depends on country:
• m/s
• ft/s
Temperature unit Select temperature unit.
Result
The selected unit applies to:
• Temperature
• Electronic temperature parameter
(6053)
• External temperature parameter (6080)
• Reference temperature parameter
(1816)
Unit choose list Country-specific:
• °C
• °F
Density unit Select density unit.
Result
The selected unit applies to:
• Output
• Simulation process variable
Unit choose list Country-specific:
• kg/dm³
• lb/ft³
Length unit Select the unit of length. Unit choose list Country-specific:
• mm
• in
10.4.3 Configuring the measuring point
The "Measuring point " wizard guides you systematically through all the parameters that
must be set for the configuration of the measuring point.
Navigation
"Setup" menu → Measuring point
‣
Measuring point
Measuring point configuration
→  88