Endress+Hauser Proline Prosonic Flow W 400 - Assign Pulse Output (0460); Failure Mode (0480); Operating Mode (0469); Pulse Scaling (0455)

Commissioning Proline Prosonic Flow W 400 HART
96 Endress+Hauser
Configuring the pulse output
Navigation
"Setup" menu → Pulse/frequency/switch output 1 to n
‣
Pulse/frequency/switch output
1 to n
Operating mode
→  96
Assign pulse output
→  96
Value per pulse
→  96
Pulse width
→  96
Failure mode
→  96
Invert output signal
→  96
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
entry
Factory setting
Operating mode – Define the output as a pulse,
frequency or switch output.
• Pulse
*
• Frequency
*
• Switch
*
–
Assign pulse output The Pulse option is selected in
Operating mode parameter.
Select process variable for
pulse output.
• Off
• Volume flow
• Mass flow
–
Pulse scaling The Pulse option is selected in
the Operating mode
parameter (→  96) and a
process variable is selected in
the Assign pulse output
parameter (→  96).
Enter quantity for measured
value at which a pulse is
output.
Positive floating
point number
Depends on country
and nominal
diameter
Pulse width The Pulse option is selected in
the Operating mode
parameter (→  96) and a
process variable is selected in
the Assign pulse output
parameter (→  96).
Define time width of the
output pulse.
0.05 to 2 000 ms –
Failure mode The Pulse option is selected in
the Operating mode
parameter (→  96) and a
process variable is selected in
the Assign pulse output
parameter (→  96).
Select output behavior in the
event of a device alarm.
• Actual value
• No pulses
–
Invert output signal – Invert the output signal. • No
• Yes
–
* Visibility depends on order options or device settings