Endress+Hauser Proline Prosonic Flow W 400 - Defining the Tag Name

Commissioning Proline Prosonic Flow W 400 HART
84 Endress+Hauser
X X X X X X XX X
20.50
XXXXXXXXX
XXXXXXXXX
mA
1.
2.
3.
Display/operat.
Setup
Diagnostic
Display/operat.
Setup
Main menu
English
Main menu
Medium selection
/ ../Setup
Display language
A0032222-EN
 48 Navigation to "Setup" menu using the example of the local display
The number of submenus and parameters can vary depending on the device version.
Certain submenus and parameters in these submenus are not described in the
Operating Instructions. Instead a description is provided in the Special Documentation
for the device ("Supplementary documentation"→  171).

Setup
‣
System units
→  85
‣
Measuring point
→  86
‣
Installation status
→  90
‣
Status input 1
→  92
‣
Current output 1
→  93
‣
Pulse/frequency/switch output
→  94
‣
Display
→  100
‣
Low flow cut off
→  102
‣
Advanced setup
→  104
10.4.1 Defining the tag name
To enable fast identification of the measuring point within the system, you can enter a
unique designation using the Device tag parameter and thus change the factory setting.