Endress+Hauser Proline Prosonic Flow W 400 - Simulation

Commissioning Proline Prosonic Flow W 400 HART
114 Endress+Hauser
Parameter overview with brief description
Parameter Description Selection
Device reset Reset the device configuration - either entirely or in part - to a
defined state.
• Cancel
• To delivery settings
• Restart device
• Restore S-DAT backup
*
* Visibility depends on order options or device settings
10.6 Simulation
Via the Simulation submenu, it is possible to simulate various process variables in the
process and the device alarm mode and verify downstream signal chains (switching valves
or closed-control loops). The simulation can be performed without a real measurement (no
flow of medium through the device).
The parameters displayed depend on:
• The selected device order
• The set operating mode of the pulse/frequency/switch outputs
Navigation
"Diagnostics" menu → Simulation
‣
Simulation
Assign simulation process variable
→  115
Process variable value
→  115
Status input 1 simulation
→  115
Input signal level 1
→  115
Current output 1 simulation
→  115
Current output value
→  115
Frequency output 1 to n simulation
→  115
Frequency output 1 to n value
→  115
Pulse output simulation 1 to n
→  115
Pulse value 1 to n
→  115
Switch output simulation 1 to n
→  115
Switch state 1 to n
→  115
Device alarm simulation
→  115