Endress+Hauser Proline Prosonic Flow W 400 - Failure Frequency (0474); Failure Mode (0451); Maximum Frequency Value (0454); Measuring Value at Maximum Frequency

Proline Prosonic Flow W 400 HART Commissioning
Endress+Hauser 97
Configuring the frequency output
Navigation
"Setup" menu → Pulse/frequency/switch output 1 to n
‣
Pulse/frequency/switch output
1 to n
Operating mode
→  97
Assign frequency output
→  97
Minimum frequency value
→  97
Maximum frequency value
→  98
Measuring value at minimum
frequency
→  98
Measuring value at maximum
frequency
→  98
Failure mode
→  98
Failure frequency
→  98
Invert output signal
→  98
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
entry
Factory setting
Operating mode – Define the output as a pulse,
frequency or switch output.
• Pulse
*
• Frequency
*
• Switch
*
–
Assign frequency output The Frequency option is
selected in Operating mode
parameter (→  96).
Select process variable for
frequency output.
• Off
• Volume flow
• Mass flow
• Flow velocity
• Sound velocity
• Temperature
• Density
• Electronics
temperature
• Signal strength
*
• Signal to noise
ratio
*
• Acceptance rate
*
• Turbulence
*
–
Minimum frequency value The Frequency option is
selected in the Operating
mode parameter (→  96)
and a process variable is
selected in the Assign
frequency output parameter
(→  97).
Enter minimum frequency. 0.0 to 10 000 Hz –