Endress+Hauser Proline Prosonic Flow W 400 - Function Scope of Control Totalizer Parameter; Performing a Totalizer Reset

Operation Proline Prosonic Flow W 400 HART
124 Endress+Hauser
11.6 Performing a totalizer reset
The totalizers are reset in the Operation submenu:
• Control Totalizer
• Reset all totalizers
Navigation
"Operation" menu → Totalizer handling
‣
Totalizer handling
Control Totalizer 1 to n
→  124
Preset value 1 to n
→  124
Totalizer value 1 to n
→  124
Reset all totalizers
→  124
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
entry / User
interface
Factory setting
Totalizer 1 to n control A process variable is selected
in the Assign process variable
parameter (→  106) of the
Totalizer 1 to n submenu.
Control totalizer value. • Totalize
• Reset + hold
• Preset + hold
• Reset + totalize
• Preset + totalize
• Hold
–
Preset value 1 to n A process variable is selected
in the Assign process variable
parameter (→  106) of the
Totalizer 1 to n submenu.
Specify start value for totalizer.
Dependency

The unit of the selected
process variable is
defined in the Unit
totalizer parameter
(→  106) for the
totalizer.
Signed floating-point
number
Depends on country:
• 0 m³
• 0 ft³
Totalizer value One of the following options is
selected in the Assign process
variable parameter
(→  106) of the Totalizer
1 to n submenu:
• Volume flow
• Mass flow
Displays the current totalizer
counter value.
Signed floating-point
number
–
Reset all totalizers – Reset all totalizers to 0 and
start.
• Cancel
• Reset + totalize
–
11.6.1 Function scope of "Control Totalizer" parameter
Options Description
Totalize The totalizer is started or continues running.
Reset + hold The totaling process is stopped and the totalizer is reset to 0.