Endress+Hauser Proline Prosonic Flow W 400 - Page 106

Commissioning Proline Prosonic Flow W 400 HART
106 Endress+Hauser
Totalizer 1 to n operation mode
→  106
Totalizer 1 to n failure behavior
→  106
Parameter overview with brief description
Parameter Prerequisite Description Selection Factory setting
Assign process variable 1 to n – Select process variable for
totalizer.
• Off
• Volume flow
• Mass flow
Volume flow
Process variable unit 1 to n A process variable is selected
in the Assign process variable
parameter (→  106) of the
Totalizer 1 to n submenu.
Select the unit for the process
variable of the totalizer.
• g
*
• kg
*
• t
*
• oz
*
• lb
*
• STon
*
• cm³
*
• dm³
*
• m³
*
• ml
*
• l
*
• hl
*
• Ml Mega
*
• af
*
• ft³
*
• Mft³
*
• Mft³
*
• fl oz (us)
*
• gal (us)
*
• kgal (us)
*
• Mgal (us)
*
• bbl (us;liq.)
*
• bbl (us;beer)
*
• bbl (us;oil)
*
• bbl (us;tank)
*
• gal (imp)
*
• Mgal (imp)
*
• bbl (imp;beer)
*
• bbl (imp;oil)
*
• None
*
Depends on country:
• m³
• ft³
Totalizer 1 to n operation mode A process variable is selected
in the Assign process variable
parameter (→  106) of the
Totalizer 1 to n submenu.
Select totalizer operation
mode, e.g. only totalize
forward flow or only totalize
reverse flow.
• Net
• Forward
• Reverse
Net flow total
Totalizer 1 to n failure behavior A process variable is selected
in the Assign process variable
parameter (→  106) of the
Totalizer 1 to n submenu.
Select totalizer behavior in the
event of a device alarm.
• Hold
• Continue
• Last valid value +
continue
Stop
* Visibility depends on order options or device settings