Proline Prosonic Flow W 400 HART Technical data
Endress+Hauser 169
3. Select Downloads.
CE mark The device meets the legal requirements of the applicable EU Directives. These are listed in
the corresponding EU Declaration of Conformity along with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.
UKCA marking The device meets the legal requirements of the applicable UK regulations (Statutory
Instruments). These are listed in the UKCA Declaration of Conformity along with the
designated standards. By selecting the order option for UKCA marking, Endress+Hauser
confirms a successful evaluation and testing of the device by affixing the UKCA mark.
Contact address Endress+Hauser UK:
Endress+Hauser Ltd.
Floats Road
Manchester M23 9NF
United Kingdom
www.uk.endress.com
RCM marking The measuring system meets the EMC requirements of the "Australian Communications
and Media Authority (ACMA)".
Ex-approval The devices are certified for use in hazardous areas and the relevant safety instructions are
provided in the separate "Control Drawing" document. This is referenced on the nameplate.
HART certification HART interface
The measuring device is certified and registered by the FieldComm Group. The measuring
system meets all the requirements of the following specifications:
• Certified according to HART 7
• The device can also be operated with certified devices of other manufacturers
(interoperability)
Radio approval The measuring device has radio approval.
For detailed information on the radio approval, see the Special Documentation
→ 172
External standards and
guidelines
• EN 60529
Degrees of protection provided by enclosure (IP code)
• EN 61010-1
Safety requirements for electrical equipment for measurement, control and laboratory
use - general requirements
• IEC/EN 61326-2-3
Emission in accordance with Class A requirements. Electromagnetic compatibility (EMC
requirements).
• ANSI/ISA-61010-1 (82.02.01)
Safety Requirements for Electrical Equipment for Measurement, Control and Laboratory
Use - Part 1 General Requirements
• CAN/CSA-C22.2 No. 61010-1-12
Safety Requirements for Electrical Equipment for Measurement, Control and Laboratory
Use - Part 1 General Requirements
• NAMUR NE 21
Electromagnetic compatibility (EMC) of industrial process and laboratory control
equipment
To Next Page
Loading...
