TS-10 Musician’s Manual Section 10 — Understanding the Sequencer
13
button next to that track. This defines the track and puts the currently selected sound on it.
Otherwise, you can just leave Track 1 selected and start from there.
3) Select a Sound for the Track:
• Press Replace Track Sound. The display shows Program Bank pages; the Sounds LED is
flashing.
• Select a sound as you normally would, using the BankSet button and the ten Bank buttons to
locate the sound you want, and then selecting it by pressing its soft button.
• Press Replace Track Sound again to return to the Seq/Song Tracks page. The new sound is
now assigned to the track.
4) Check the CLICK and COUNTOFF settings:
• Press Click. This page controls all the functions of the TS-10’s built-in metronome. Underline
the CLICK parameter and set to CLICK=REC. This will provide a click track when you are in
record, but not during playback.
• Underline the COUNTOFF parameter and set to COUNTOFF=REC. This will play a one bar
countoff before recording (but not when playing back) all tracks after the first. The TS-10 will
display CNTF in the lower-left-hand corner of the display during countoff (when enabled on
the Click page):
CNTF appears during
sequencer countoff
5) Record the First Track:
The length of the first track defines the length of the sequence. For this reason, there is a special
procedure for recording the first track of a new sequence.
• While holding down Record, press Play. The click track starts playing, giving the tempo. The
first beat of each measure is emphasized.
• Adjust the tempo. Press Locate. The Tempo parameter is always selected on this page. Use
the Data Entry Slider and the Up/Down Arrow buttons to set it to the tempo you want. Or,
with the sequencer running, you can tap on the soft button below the TEMPO parameter at the
desired tempo.
• Play the keyboard to begin recording. The bar in which you start playing becomes Bar 1 of the
sequence.
• Press Stop/Continue (or the assigned AUX Foot Switch) to end recording.
The display will ask “KEEP FIRST TRACK?” The length (in bars) of the first track is shown in
the lower left corner of the display. This will determine the length of the sequence.
• Press *YES* to keep the track, defining the length of the sequence, or
• Press *NO* to erase the first track and start over again.
6) Record Additional Tracks:
After you have answered *YES* to the question “KEEP FIRST TRACK?,” all other recording,
including re-recording the first track, will follow the same basic routine. The length of the
sequence is now defined (by the length of the first track). The rest of the tracks will automatically
have the same length.
• Press the Seq/Song Tracks 1-6 button, and select a second track by pressing the soft button of
any -UNDEFINED- track (or leave the first track selected if you want to record over it). The
name of the sound and all the track parameters from the previous track are copied onto to the
new track.
• Select a sound for the track. As shown in step 3 above, use the Replace Track Sound function
To Next Page
Loading...
Need help?
General
