Section 11 — Sequencer Parameters TS-10 Musician’s Manual
4
FS stands for Foot Switch. In order to use this function you must first assign one of the Foot
Switches (on the System page) to SONG-STEP. When REPS=FS, the song step will loop
continuously until the assigned foot switch is pressed. When the foot switch is pressed, the
current step will finish playing and then advance to the next step.
TRACKS
Selecting this option from the song step editor page displays a sub-page which allows you to
Mute or Transpose specified tracks for the current song step.
Tracks 1-6 Tracks 7-12
Tracks 1-6 Tracks 7-12
STEP
Shows the current step number. Pressing this button again when it is already selected will return
you to the Song Step Editor page.
MUTE TRACKS Range: P (Play) or M (Mute)
The number 2 and 3 soft buttons each select a group of 6 positions which control the muting of
sequence tracks for the current song step. Repeated presses of the soft button will scroll across
the set of 6 tracks, and allow each track to be muted or unmuted individually. An M indicates
that the track is muted for the entire step, and a P indicates that the track will play.
TRANSPOSE Range: -12 to +12 semitones
Sets the transpose amount to be used by any tracks which are set to Transpose for that song step
(see below). This will raise or lower the pitch of the entire track.
TRANSPOSE TRACKS Range: N (Normal) or T (Transposed)
The number 5 and 6 soft buttons each select a group of 6 positions which control the
transposition of tracks for the current song step. Repeated presses of the soft button will scroll
across the set of 6 tracks, and allow each track to be transposed or left normal (no transposition)
individually. A T indicates that the track will be transposed, and an N indicates that the track
will play at normal pitch.
To Next Page
Loading...
Need help?
General
