Section 11 — Sequencer Parameters TS-10 Musician’s Manual
32
will play at their designated tempo.
When a Song Tempo Track is selected, editing this value will record tempo change events.
GOTO — Sequence Autolocate Control
Displays the GOTO sub-page where the auto-locator destination is set. Using the GOTO function
you can quickly locate to any bar and beat within the sequence, in order to play or record from
there.
• Press GOTO. The display shows:
GOTO will be flashing and the destination may be set using the Data Entry Slider or the
Up/Down Arrow buttons. Notice there is now a cursor (underline) beneath the bar value at
the BAR/BEAT parameter. Press the soft button beneath BAR/BEAT to move the cursor
between the Bar and Beat. Continued presses of the BAR/BEAT parameter will toggle
between the bar and beat values.
• After selecting a new location to go to, press the GOTO soft button again to complete the
locating process and return to the main Locate page. The GOTO function provides a quick
and easy way to repeatedly locate to a certain place in a sequence — the destination remains
set until a new sequence or song is selected.
• After using the GOTO function to locate to a spot in the sequence, press Stop/Continue to
begin playing the sequence from that point.
Setting the GOTO Locate Time While the Sequence Plays
You can set the location of the GOTO time “on the fly” as the sequence plays:
• Press Play to begin playing the sequence.
• When the sequence reaches the point where you want to set the GOTO location, press GOTO.
The display momentarily shows LOCATE TIME SET - STOP TO LOCATE, and installs that
time as the GOTO location.
• Press Stop•Continue (or let the sequence end).
• Now if you press GOTO twice, it will go to the same location that was set as when it was
playing.
To Next Page
Loading...
Need help?
General
