Section 2 — System Page Parameters TS-12 Musician’s Manual
10
WAKE-UP-MODE Range: SOUNDS, PRESETS, SEQ/SONG, DEFAULT,
PREVIOUS, LASTPAGE, GEN-MIDI
This parameter determines which mode the TS-10 will “wake-up” in after power-on.
• SOUNDS — Power-on in Sounds mode with the last Sound selected before power-off selected.
• PRESETS — Power-on in Presets mode with the last Preset selected before power-off selected.
• SEQ/SONG — Power-on in Sequencer mode with the last Sequence or Song selected.
• DEFAULT — Power-on in Sounds mode showing Program Bank U0-0. The default sound in
ROM will be selected.
• PREVIOUS — Power-on in the same mode the TS-10 was in when it was powered-off. Note
that if the TS-10 was in General MIDI mode when it was powered-off, it will wake-up in
Sounds mode.
• LASTPAGE — Power-on showing the last page that the TS-10 was on when it was powered-off.
This does not apply to some editing sub-pages. Note that if the TS-10 was in General MIDI
mode when it was powered-off, it will wake-up showing the last page that the TS-10 was on
before entering General MIDI mode.
• GEN-MIDI — Power-on in General MIDI mode.
Note: When WAKE-UP-MODE=GEN-MIDI, and Sampled Sounds had previously been loaded, the
Auto-Load prompt will be displayed before the TS-10 enters General MIDI. To prevent this, you
can first erase all Sampled Sounds from memory, as described in Section 14 — Understanding
Sampled Sounds.
To Next Page
Loading...
