Section 11 — Sequencer Parameters TS-10 Musician’s Manual
18
KEY-VELOCITY — Note-On Velocity
CNTL-1.MODWHL — Mod Wheel
CNTL-4.PEDAL — Foot Pedal
CNTL-7.VOLUME — Volume Pedal
CNTL-10.PAN — Track or MIDI Pan
CNTL-64.SUSTN — Sustain Foot Switch
CNTL-66.SOSTU — Sostenuto Foot Switch
CNTL-12.FX-SW — Effect Mod Foot Switch
CNTL-70.PSEL — Patch Select Buttons
CNTL-71.TIMBR — Track Timbre Controller
CNTL-72.RELS — Track Release Time Controller
CNTL-73.ATTAK — Track Attack Time Controller
CNTL-74.BRITE — Track Brightness Controller
CNTL-75.RATE — Track Rate Controller (LFO Rate and/or Wave-List Duration)
CNTL-XX.XCTRL — Track External MIDI Controller
ALL.CONTROLRS — All Controllers
CHAN-PRESSURE — Channel (mono) Pressure
MIXDWN-VOLUME — Mixdown Volume
MIXDOWN-PAN — Mixdown Pan
TEMPO — Tempo Track Events (note that SCALE will have no effect on TEMPO events)
PITCH-BEND — Pitch Bend Wheel
• If you wish to scale a specific range rather than the entire track, press RANGE and set the time
and/or key range on the Edit Track Range page, as shown earlier in this section. If not, leave
it set to RANGE=ALL.
• Press *YES* to execute the Scale command (or press *NO* to cancel). After editing, the TS-10
returns with the Audition Play/Keep page where you can audition the results of the edit
before deciding whether to keep it or not.
EVENT-LIST
The Event List function provides you with an extremely powerful tool for viewing and editing
each event in the track. Every key event, controller change and program change can be
individually located and edited.
• Make sure the track you want to edit is selected.
• Press Edit Track twice (or press *MORE* from the Edit Track page), then select EVENT-LIST.
The display shows:
Event-Type Filter:
Limits what will be listed
Number of Current
Event from start of track
Event
Type
Key #
/Value
Veloc.
/Value
Type, Key number and
value for Current Event
Starting Time of
Current Event
Press to Exit to
Play/Keep page
Press to Edit
Current Event
Bar Beat Clock