TS-10 Musician’s Manual Section 11 — Sequencer Parameters
19
EVENT-TYPE
Controls which types of events will be shown as you scroll up through the events in the track.
When set to ALL, every event in the track will be listed. On the other settings, some types of
events will be left out of the list — when the Event Number (below) is changed, the display will
jump directly to the next event of the type shown, skipping other types. The Event Types which
can be selected here are:
MOD — Mod Wheel
PED — Foot Pedal
VOL — Volume Pedal
PAN — Track or MIDI Pan
SUS — Sustain Foot Switch
SOS — Sostenuto Foot Switch
FXS — Effect Mod Foot Switch
PSL — Patch Select Buttons
TMB — Track Timbre Controller
REL — Track Release Time Controller
ATK — Track Attack Time Controller
BRT — Track Brightness Controller
RAT — Track Rate Controller (LFO Rate and/or Wave-List Duration)
XCC — XCTRL: Track External MIDI Controller
CNT — All Controllers
CPS — Channel (mono) Pressure
MXV — Mixdown Volume
MXP — Mixdown Pan
TMP — Tempo Track events
BND — Pitch Bend Wheel
KPS — Poly-Key Pressure
PRG — Program Changes and Bank Selects
KEY — Note Events only; no Controllers
ALL — All Events of all types
TIME
Shows the current time in terms of Bar, Beat and Clock. These three TIME fields can be
individually selected by repeated presses of the soft button. Use the Up/Down Arrows to step
ahead or back in time by bars, beats or clocks, depending on which field is selected.
NUM — Event Number
When this field is selected, you can use the data entry controls to step ahead or back in time
among the events in the track to find the one(s) you want to edit. When you press the Up Arrow
button, it will advance to the next event of the type specified in Event Type. Moving the Data
Entry Slider will scroll quickly through all the events in the track. You will hear the notes in the
sequence play as you step through the track.
EVENT
This shows the type and value of the current event. The first segment of this readout is always
the Event Type. For Key events Poly-Key pressure events, and Program Change events there are
two additional segments; for all other event types there is one additional segment:
• On Key events, the display shows: EVENT=KEY.C4.115. The three segments represent Event
Type; Key Number; and Velocity.
• On Poly-Key pressure events, the display shows EVENT=KPS.C4.115. The three segments
represent Event Type; Key Number; and pressure Value.
• On Program Change events, the display shows: EVENT=PRG.000.000.B. The last three
segments represet Event Type, Program Number, and Bank Select Number (followed by a “B”).
• For all other Event types, the display shows the Event Type and the Value.
To Next Page
Loading...
Need help?
General
