Section 5 — Preset/Track Parameters TS-10 Musician’s Manual
10
• Press the Controllers On/Off button a fourth time to get to the Mod Wheel page:
Mod Wheel Page Range: OFF or ON
The Mod Wheel Page is used to determine which track(s) will respond to the Modulation Wheel,
when assigned as a controller for any of the modulatable parameters.
• Press the Controllers On/Off button a fifth time to get to the All-Notes-Off page:
All-Notes-Off Page Range: OFF or ON
The All-Notes-Off Track parameter determines how the sequencer will handle note-off
transmission. This parameter is visible on Preset Tracks, but does not really apply to Presets.
When OFF, the TS-10 will transmit key-up messages for every note currently sounding when the
Sequencer Stop/Continue button is pressed to stop the Sequencer. When ON, the TS-10 will send
an ALL-NOTES-OFF message in addition to all of the key-ups when the Sequencer
Stop/Continue button is pressed to stop the sequencer.
• Press the Controllers On/Off button a sixth time to get to the Reset Controllers page:
Reset Controllers Range: OFF or ON
The RSET parameter determines whether or not the TS-10 will transmit the MIDI Reset
Controllers message, in addition to transmitting a default value for every controller on each
Track, in the following instances:
1) each time the Sequencer Stop/Continue button is pressed to stop the Sequencer
2) each time a Song Step ends
3) each time a Song loops back to the beginning.
This parameter is visible on Preset Tracks, but does not really apply to Presets.
To Next Page
Loading...
Need help?
General
