EasyManuals Logo

ENSONIQ TS-10 User Manual

ENSONIQ TS-10
372 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
Section 6 — Understanding Effects TS-10 Musician’s Manual
4
4) When you change the sound on a track by double-clicking the Replace Track Sound button
(e.g. with the Sounds and the Replace Track Sound LED flashing), the algorithm will be
changed.
5) When you select a preset, the algorithm saved in that preset will be loaded into the ESP.
6) When you select a song or sequence, the algorithm saved in that song or sequence will be
loaded into the ESP.
7) Whenever you go from Sounds mode to Sequencer mode (by pressing Seqs/Songs) the
sequencer algorithm is loaded. The same is true when going from Sequencer mode to
Sounds mode (by pressing Sounds).
8) Saving either the sound or the preset will save the current algorithm.
9) Should you start editing a sound while an algorithm other than its own is active, a warning
will appear, reminding you that you are not hearing the algorithm you are seeing or editing.
This warning appears as MUTE, flashing in the lower left corner of the display.
10) When MIDI program changes 60-119 are received in MULTI or MONO B modes, the
sequence or song effect algorithm will be loaded with the one in the program change.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ENSONIQ TS-10 and is the answer not in the manual?

ENSONIQ TS-10 Specifications

General IconGeneral
BrandENSONIQ
ModelTS-10
CategorySynthesizer
LanguageEnglish

Related product manuals