Epson C Series - Replacing the LED Lamp

C4 Maintenance 14. Replacing the LED Lamp
158 C Series Maintenance Manual Rev.2
14. Replacing the LED Lamp
WARNING
■
Do not connect or disconnect the motor connectors while the power to the robot
system is turned ON. Connecting or disconnecting the motor connectors
with
the power ON is extremely hazardous and may result
in serious bodily injury as
the Manipulator may mo
ve abnormally, and also may result in electric shock
and/or malfunction of the robot system.
■
To shut off power
to the robot system, disconnect the power plug from the power
source. Be sure to connect the AC power cable to a power receptacle.
DO NOT connect it directly to a factory power source.
■
Before performing any replacement procedure, turn OFF the Controller and
related equipment,
and then disconnect the power plug from the power source.
Performing any replacement procedure with the power ON is extremely hazardous
and may result in
electric shock and/or malfunction of the robot system.
LED lamp
Name Quantity Note
Maintenance Parts LED lamp 1
For the part code, refer to the 17. C4
Maintenance Part List.
Tools
Cross-point screwdriver
1
For covers