Epson C Series User Manual

C8 Maintenance 3. Covers
196 C Series Maintenance Manual Rev.2
3. Covers
This chapter describes methods of removing and installing the covers and gaskets which are
common to all maintenance procedures by Manipulator model.
S: Standard model
C: Clean-room & ESD model
P: Protection model
WARNING
■
Do not connect or disconnect the motor connectors while the power to the robot
system is turned ON. Connecting or disconnecting the motor connectors with
the power ON is extremely hazardous and may result in serious bodily injury as
the Manipulator may move abnormally, and also may result in electric shock
and/or malfunction of the robot system.
■
To shut off power to the robot system, disconnect the power plug from the power
source. Be sure to connect the AC power cable to a power receptacle.
DO NOT connect it directly to a factory power source.
■
Before performing any replacement procedure, turn OFF the Controller and
related equipment, and then disconnect the power plug from the power source.
Performing any replacement procedure with the power ON
is extremely
hazardous and may result in electric shock and/or malfunction of the robot
system.
■
Be careful not to get any foreign substances in the Manipulator, connectors, and
pins during maintenance. Turning ON the power to the robot system when any
foreign substances exist in them is extremely hazardous and may result in electric
shock and/or malfunction of the robot system.

Epson C Series Specifications

General

Brand	Epson
Model	C Series
Category	Robotics
Language	English