Epson C Series - Page 239

C8 Maintenance 3. Covers
C Series Maintenance Manual Rev.2 219
C8-A701** (C8), C8-A901** (C8L)
Installation
(S, C models)
Install the connector plate to the Manipulator.
Hexagon socket head cap bolts: 11-M4×10
Tightening Torque: 4.0 ± 0.2 N·m
Be careful not to get the cables caught between the cover and the Manipulator.
C8-A701** (C8), C8-A901** (C8L)
Installation
(P model)
1.
Install the spacers to the holes on the gasket.
(11 places)
2.
Apply the liquid gasket to the base rear gasket.
Install the base rear gasket to the connector plate.
(See the figure for gasket applying points)
Base rear gasket
Gasket
Applying
point (×11)
Spacer (×11)
Connector plate
After applying the liquid gasket, leave the gasket until the liquid gasket becomes solid
and the gasket is fixed.
3.
Install the connector plate to the Manipulator.
Hexagon socket head cap bolts: 11-M4×10
Tightening torque: 4.0 ± 0.2 N·m
Be careful not to get the gasket and cables caught between the cover and the
Manipulator.
Replace the gasket if there are flaws or deteriorations.

NOTE

NOTE