C8 Maintenance 4. Cable Unit
226 C Series Maintenance Manual Rev.2
CAUTION
â–
disconnecting the connectors during the replacement of the cable unit, be
sure to reconnect the connectors to their proper positions.
Improper connection of the connectors may result in improper function of the robot
system.
For details on the connections, refer to
the C8 Maintenance 4.2 Connector Pin
Carefully use alcohol and adhesive following respective instructions and also
instructions below. Otherwise, it may cause a fire and/or safety problems.
- Never put alcohol or adhesive close to fire.
- Use alcohol or adhesive while ventilating the room.
- Wear protective gear including a mask, protective goggles, and oil-resistant
gloves.
- If alcohol or adhesive gets on your skin, wash the area thoroughly with soap
and water.
- If alcohol or adhesive gets into your eyes or mouth, flush your eyes or wash
out your mouth with clean water thoroughly, and then see a doctor
immediately.
Wear protective gear including a mask, protective goggles, and oil-resistant gloves
during grease up. If grease gets into your eyes,
mouth, or on your skin, follow
If grease gets into your eyes : Flush them thoroughly with clean water, and
then see a doctor immediately.
If grease gets into your mouth : If swallowed, do not induce vomiting. See a
doctor immediately.
If grease just gets into your mouth, wash out
your mouth with water thoroughly.
If grease gets on your skin : Wash the area thoroughly with soap and
To Next Page
Loading...
Need help?
General
