Epson C Series - Page 429

C8 Maintenance 15. Replacing the Fan
C Series Maintenance Manual Rev.2 409
(Figure: Cable backward model)
Removal: Fan
1.
Remove the fan cover screws while supporting the cover.
Cross recessed head screws with washer: 4-M4×35
The cover falls when the screws are removed.
When removing the screws, be sure to support the cover.
2.
Remove the fan cover.
3.
Remove the fan connectors.
4.
Remove the fan.
Installation: Fan
1.
Install the fan.
Be careful of the installation direction of the fan.
The arrow on the fan
(indicated with the arrow in the photo) should point the
heat sink, and the cables should come to the upper side of the fan.
Heat sink side
2.
Connect the fan connectors.
3.
Install the fan cover.
Cross recessed head screws with washer: 4-M4×35
Tightening torque: 0.9 ± 0.1 N·m

NOTE

NOTE