Epson C Series - Page 54

C4 Maintenance 4. Cable Unit
34 C Series Maintenance Manual Rev.2
16.
Wrap the end of the spring to the fixing plate with a wire tie. (a)
Temporally bind the cables to the Arm #4 cable fixing plate. (b)
Wire tie: AB150
Silicone sheet: 15 mm × 50 mm
(a)
(b)
Precautions for cable unit fixation to the plate
Place the silicone sheet on the plate as shown in the photo on
the right (example). Fix the wire tie at the center of the
silicone sheet.
17.
Temporarily fix the Arm #4 cable fixing plate to the Arm #4.
Hexagon socket head cap bolt: 2-M4×10
18.
Temporarily bind the cables coming from the Arm #4.
Wire tie: AB150
Mark tube: 46 mm
Precautions for cable unit fixation to the plate:
Pass the mark tube and the wire tie through the hole of the plate
as shown in the right photo.

NOTE

NOTE