Epson RC700 Series - Page 290

Maintenance 9. Troubleshooting
278 RC700 / RC700-A Rev.23
No. Message Remedy Note 1 Note 2
7300
Vision Communication.
Server mode not supported.
-
7302
Vision Communication.
Failed to read from the camera.
Check the connection with the
camera.
7303
Vision Communication.
Read data overflow.
Data exceeding the receive buffer
was received.
7304
Vision Communication.
Failed to open the Ethernet port.
Check the connection with the
camera.
7305
Vision Communication.
Invalid IP address of camera.
Rebuild the project. Check the
camera configuration.
7306
Vision Communication.
No specification of Server or Client.
-
7307
Vision Communication.
Failed to send to the camera.
Check the connection with the
camera.
7308
Vision Communication.
Camera version is old.
The version of the connected camera
is old. Update the camera.
7321
Vision Communication.
Camera setting has not been set.
Rebuild the project. Check the
camera configuration.
7322
Vision Communication.
Read timeout.
Check the connection with the
camera.
7323
Vision Communication.
Read invalid data.
Check the connection with the
camera.
7324
Vision Communication.
Failed to send to the camera.
Check the connection with the
camera.
7325
Vision Communication.
Connection is not completed.
Check the connection with the
camera.
7326
Vision Communication.
Read data is too long.
-
7327
Vision Communication.
Undefined vision sequence.
Check the sequence name.
7328
Vision Communication.
Camera setting has not been set.
Rebuild the project. Check the
camera configuration.
7329
Vision Communication.
Vis file was not found.
Rebuild the project. Check the
camera configuration.
7330
Vision Communication.
Failed to allocate memory.
Reduce the number of sequences,
objects, and calibration.
7341
Vision Communication.
Out of max camera number.
Review the camera registration.
7342
Vision Communication.
Invalid camera number.
Review the camera registration.
7343
Vision Communication.
VSet parameter is too long.
Review the names and string
variables of sequences, objects, and
calibration.
7344
Vision Communication:
Too many parameters for VGet.
The number of specified variables is
exceeding 32. Reduce the number
of parameters.
7345
Vision Communication.
Not enough data for VGet
statement variable assignment.
Reboot the camera.
Check the version of the camera.
7346
Vision Communication.
Cannot execute a Vision statement
from the command window.
Execute the command from the
program.
7400
Matrix determinate too small.
If specifying the virtual camera,
specify the real camera.
7402
Invalid value for maximum motion
distance.
Specify the valid value.