Epson Stylus Pro GS6000 - Page 128

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 128
Confidential
4.4.7.5 CR ENC ASSY
1. Remove the TOP COVER (left only). (p85)
2. Remove the MAINTE COVER T. (p86)
3. Remove the SIDE COVER (left only). (p89)
4. Remove the IH COVER (left only). (p90)
5. Unlock the Carriage. (p83)
6. Remove the CR Top Cover (Step 6 to 9 in 4.4.5.3 COOLING FAN). (p104)
7. Disconnect all the connectors except J13 and J14 and release the cables from the
clamps on top.
.
Figure 4-89. Disconnecting the cables
8. Move the Carriage to the platen, and remove the four screws from the hole on the rear left.
A) Silver, Phillips, Cup M3x6: two pieces
B) Silver, Phillips, Pan with S.W & P.W M3x8: two pieces
.
Figure 4-90. Removing the screws from the hole on the rear
9. Move the Carriage to the left end and remove the five screws (one securing the
GND terminal together).
A) Silver, Phillips, Pan with S.W & P.W M3x8: four pieces
B) Silver, Phillips, Cup M3x6: one piece
10. Release all the cables from the clamps on the side.
Figure 4-91. Removing the screws on the Top Frame
J14 J13
SUB_A BOARD ASSY
Carriage
As seen from the top
B
A
As seen from the rearAs seen from the rear
B
A
As seen from the top
[Step 12]
Open it to the left
Clamps
Top Frame
SUB_A BOARD