Epson Stylus Pro GS6000 - Page 150

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 150
Confidential
10. Holding the shaft from under, remove the screw and the shaft.
A) Silver, Hexagon socket M3x8: four pieces
11. Pressing the bearing down and remove the CR LOCK SOLENOID.
Figure 4-119. Removing the CR LOCK SOLENOID
C A U T I O N
In the next step, the shaft will drop unless holding it from under the
shaft when removing the screw.
 When routing the cable, make sure to give it one turn around
the marked clamp. See Figure 4-115.
 Make sure the bearing is correctly lubricated and moves
smoothly before reassembling. See p253 for Lubrication
details.
A
As seen from the front
CR LOCK SOLENOID
Shaft
Bearing
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p184) and perform
specified adjustments after replacing or removing this part.
<Adjustment item>
1. Solenoid Test