Epson Stylus Pro GS6000 - Page 153

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 153
Confidential
9. Slide the LOWER BEARING in the direction of the arrow, and remove the pin of
it from the main body.
10. Move the spring below and remove it from the cursor.
Figure 4-123. Removing the Cursor
11. Remove the Spring from the LOWER BEARING.
Figure 4-124. Removing the Spring
C A U T I O N
 When removing the LOWER BEARING, make sure to remove
it while supporting it at the bottom. Otherwise; if removed with
the spring extended, it might be damaged.
 When removing the spring, be careful not to let it pop.
Cursor
Spring
LOWER BEARING
LOWER BEARING
Spring
1. Attach the spring removed from the LOWER BEARING.
2. Hold the cursor at the top so as not to let it move, attach the
LOWER BEARING to the cross-shaped rib on the cursor.
3. Insert the left dowel of the LOWER BEARING into the hole on
the cursor to the full.
Cursor
LOWER BEARING
Cursor
Hole
LOWER BEARING