Epson Stylus Pro GS6000 - Page 168

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 168
Confidential
7. Remove the four screws and remove the PUMP ASSYs with the fixing plate.
A) Silver, Phillips, Pan with S.W & P.W M4x6: four pieces
Figure 4-145. Removing the PUMP ASSYs with the fixing plate
 Connect the tubes (1) to (4) as shown in the figure below.
 After connecting the tubes, make sure to confirm that the tubes
are securely fitted until the end of the connector to prevent
them from dropping with vibrations.
CAP HEAD (left)
CAP HEAD (right)
[Front]
PUMP ASSY
(front)
PUMP ASSY
(inside)
1
3
2
4
A
PUMP ASSYs
As seen from the front
Fixing plate