Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 173
Confidential
4.4.11.10 INK TUBE, LEFT/INK TUBE, RIGHT
1. Discharge ink using the service program. (p210)
2. Remove the TOP COVER (both). (p85)
3. Remove the REAR COVER. (p95)
4. Unlock the Carriage. (p83)
5. Remove the MAINTE COVER T. (p86)
6. Remove the SIDE COVER (left only). (p89)
7. Remove the IH COVER (left only). (p90)
8. Open the Top Frame with SUB_A BOARD (Step 6 to 12 in 4.4.7.5 CR ENC
ASSY). (p128)
9. Remove the two screws to remove the tube holding plate.
A) Silver, Phillips, Pan with S.W & P.W M3x8: two pieces
10. Disconnect the ink tubes from tube connectors.
Figure 4-151. Disconnecting ink tubes
11. Release the ink tubes from the tube holders.
Figure 4-152. Releasing the ink tubes
12. Remove the screws (four each), and remove the two tube holding plates to release
the ink tubes.
A) Silver, Phillips, Bind P-tite M3x8: each four piece
Figure 4-153. Removing the tube holding plates
To Next Page
Loading...
