Epson Stylus Pro GS6000 - Page 175

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 175
Confidential
4.4.11.11 CR CURSOR ASSY
1. Remove the TOP COVER (both). (p85)
2. Remove the REAR COVER.(p95)
3. Unlock the Carriage. (p83)
4. Remove the MAINTE COVER T. (p86)
5. Remove the COOLING FAN (both). (p104)
6. Remove the PRINT HEAD/VALVE ASSEMBLY, HEAD (Step 5 to Step 12 in
4.4.11.1 PRINT HEAD/VALVE ASSEMBLY, HEAD). (p158)
7. Remove the PAPER EDGE SENSOR. (p127)
8. Remove the PG HEIGHT SENSOR. (p130)
9. Remove the two screws that secure the CR CURSOR ASSY.
A) Silver, Phillips, Pan with S.W & P.W M4x10: two pieces
Figure 4-155. Removing the screws
10. Detach the lower part of the CR CURSOR ASSY from the guide rail while
pinching the levers for removal on the left/right sides of the CR CURSOR ASSY.
11. Following the arrows, remove the CR CURSOR ASSY upward.
Figure 4-156. Removing the CR CURSOR ASSY
Screw A
CR CURSOR ASSY
C A U T I O N
Do not lift the lower part of the CR CURSOR ASSY too much to
avoid the bearings from getting stuck on the rail.
Lever
Step10
Lever
Step10
Step10
Step11