Epson Stylus Pro GS6000 - Page 179

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 179
Confidential
4. Remove the four screws at the back and open the Rear Cover (not an ASP).
A) Silver, Phillips, Pan with S.W & P.W M3x6: four pieces
Figure 4-161. Removing the Rear Cover
5. Disconnect all the cables from the board.
6. Remove the four screws and remove the TAKE-UP CONT BOARD ASSY.
A) Silver, Phillips, Pan with S.W & P.W M3x6: four pieces
Figure 4-162. Removing the TAKE-UP CONT BOARD ASSY
Connector assignment:
A
As seen from the rear
Rear Cover
Take-UP Reel Unit
Connector No. Color Destination
JP1
Black TAKE-UP SW ASSY
JP2
White TAKE-UP MOTOR
JP3
White TAKE-UP P/S BOARD ASSY (CN2)
JP5
White TAKE-UP SENSOR
JP6
White TAKE-UP SENSOR
A
TAKE-UP CONT BOARD ASSY
Inside the box
JP1
JP2
JP3
JP6JP5