Epson Stylus Pro GS6000 - Page 180

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 180
Confidential
TAKE-UP SW ASSY
1. Remove the Take-Up Unit Cover (p177)
2. Disconnect the TAKE-UP SENSOR.(p178)
3. Remove the TAKE-UP CONT BOARD ASSY.(p178)
4. Disconnect connector JP1 from the TAKE-UP CONT BOARD ASSY.
Figure 4-163. Disconnecting the connector
5. Remove the four screws and remove the TAKE-UP SW ASSY by drawing it out
from the top avoiding the frame.
A) Silver, Phillips, Pan with S.W & P.W M3x6: four pieces
Figure 4-164. Removing the TAKE-UP SW ASSY
TAKE-UP CONT BOARD ASSY
Inside the box
JP1
TAKE-UP SW ASSY
A
TAKE-UP SW ASSY
As seen from the top
Frame