12-6 Troubleshooting
If the EPSON Stylus Scan is connected by parallel interface
(available on Windows machines only): First unlock the wire
clips on both sides of the interface connector. Also remove the
ground connector, if necessary. Then disconnect the cable
from the Stylus Scan’s interface connector.
3. Make sure that A4 or Letter size paper is loaded in the paper
feeder.
4. Hold down the
E
load/eject button and press the
P
power
button to turn on the Stylus Scan. Then release both buttons.
The Stylus Scan prints an operation check page that include
the Stylus Scan's ROM version number, the ink counter code,
and a nozzle check pattern.
To Next Page
Loading...
