3-2 Loading the Paper
Loading the Paper
This chapter explains how to load paper and other media into the
paper feeder for printing and copying, and describes proper
handling of these media. For information on feeding documents
into the document feeder, see chapters 8 and 9.
Loading Plain Paper
Follow these steps to load plain paper for printing or copying.
1. Lower the output tray and slide out the extension. Next, slide
the left edge guide to adjust the width of the loading area so
that it is slightly wider than the width of your paper.
2. Fan a stack of paper; then tap it on a flat surface to even the
edges.
3. Load the stack of paper with the printable side up and the
right edge of the paper resting against the right side of the
paper feeder. Then slide the left edge guide against the edge
of the paper.
To Next Page
Loading...
Need help?
General
