8-2 Scanner
Loading the Document
1. Adjust the document edge guides so that distance between
them is slightly wider than the width of the document.
2. Hold the document you want to scan with the image face
down, and place the top edge of the document between the
document edge guides.
Note:
❏ Be sure to load the top of the document into the document feeder.
If the document is too wide to fit into the feeder in this direction,
try loading the document sideways. You can rotate the image
90 degrees with your software after scanning.
❏ If your document is fragile or very thin, place it in the protection
sheet before loading. See “Loading thin or fragile media” on page
8-3.
3. Close the document edge guides so that they match the width
of the document.
4. Insert the top edge of the document into the document feeder
until you feel a tug.
To Next Page
Loading...
Need help?
General
