Safety Instructions 2-3
❏ Do not attempt to service the EPSON Stylus Scan yourself.
❏ Unplug the Stylus Scan and refer servicing to qualified service
personnel under the following conditions:
❏ The power cord or plug is damaged; liquid has entered the
Stylus Scan; the Stylus Scan has been dropped or the cabinet
damaged; the Stylus Scan does not operate normally or
exhibits a distinct change in performance.
❏ To provide adequate short-circuit protection and over-
current protection for this Stylus Scan, the building
installation must be protected by a 16 Amp circuit breaker.
A Few Precautions
When using the Stylus Scan
❏ Do not put your hand inside the Stylus Scan or touch the ink
cartridges during operation.
❏ Do not move the print head by hand. Doing so may damage
the EPSON Stylus Scan.
❏ Always use the
P
power button to turn off the Stylus Scan.
After pressing this button, the
P
power light flashes briefly
then goes off. Do not unplug the Stylus Scan or turn off the
power to the outlet until the
P
power light stops flashing.
❏ Before transporting the Stylus Scan, make sure the print head
is in the home (far right) position and the ink cartridges are
in place.
When handling the ink cartridges
❏ Keep ink cartridges out of the reach of children. Do not allow
children to drink the ink or otherwise handle the cartridges.
To Next Page
Loading...
