11-14 Maintenance
Cleaning the EPSON Stylus Scan
To keep your Stylus Scan operating at its best, clean it thoroughly
several times a year.
1. Make sure the Stylus Scan is turned off and all of its lights are
off. Then unplug the power cord.
2. Remove all paper from the paper feeder.
3. Use a soft brush to carefully clean away all dust and dirt.
4. If the outer case or the inside of the paper feeder is dirty, clean
it with a soft, clean cloth dampened with mild detergent. Keep
the front cover and the top/front cover closed to prevent
water from getting inside.
5. If the inside of the Stylus Scan accidentally gets soiled with
ink, wipe the ink away with a damp cloth.
c
Caution:
❏ Never use alcohols or thinners to clean the Stylus Scan;
these chemicals can damage the components as well as
the case.
❏ Be careful to keep water away from the printing and
scanning mechanisms and electronic components.
❏ Do not use a hard or abrasive brush.
❏ Do not spray the inside of the Stylus Scan with
lubricants; unsuitable oils can damage the mechanisms.
Contact your dealer or a qualified service person if
lubrication is needed.
To Next Page
Loading...
Need help?
General
