12-14 Troubleshooting
❏ If the above does not work, replace the ink cartridges. See
“Replacing a black ink cartridge” on page 10-7 and
“Replacing a color ink cartridge” on page 10-3 for
instructions.
Paper out lights are flashing or on
❏ If the paper out light is flashing, remove any paper that may
be jammed in the Stylus Scan.
❏ If the paper out light is on, load more paper into the paper
feeder.
One of the ink out lights is flashing or on
❏ If the
B
black or
A
color ink out light is flashing, ink is low.
Prepare a replacement cartridge.
❏ If the
B
black or
A
color ink out light is on, ink is out. Replace
the corresponding cartridge. See “Replacing Empty Ink
Cartridges” on page 10-2.
All lights are flashing
Follow these steps.
1. Remove all paper from the Stylus Scan.
2. Turn the Stylus Scan off. Check for and remove any foreign
objects or pieces of paper from inside the device. Also, make
sure that there is sufficient space around the rear vent to allow
for proper ventilation. Remove any objects blocking the vent,
then turn the power back on.
3. If the error does not clear, contact your dealer.
To Next Page
Loading...
