3-4 Loading the Paper
❏ Make sure the printable side of the paper is facing up when
loading media into the paper feeder. See the instructions
included with the media to determine which side is the
printable surface. Some media come with corner cuts that help
identify the correct loading direction, as shown below.
Note:
If you extend the printable area with the Maximum setting in the
printer driver, the cut corner on special paper may mar your
printout.
❏ Make sure the paper stack fits under the arrow mark located
on the inside surface of the left edge guide.
❏ Remove any documents from the document feeder before
printing.
cut corner
printable
side up
To Next Page
Loading...
Need help?
General
