5-19
Assembly
Step
Assembly Procedure
7
8
★
Part Name
Tension plate assembly
CC (M3 x 5) x 1
Home position sensor sub as-
sembly
CBS-tite (M3 x 5) x 1
• Insert the protrusion of the Tension plate assembly from the bottom of
the Print frame sub-assembly into the rectangular hole; then tighten
the screw loosely so that the tension plate moves.
• Secure the Home position sensor sub-assembly to the Print frame
sub-assembly with the screw.
• Route the home position sensor lead wires under portion J.
<Checkpoint>
• Verify that the soldered connections on the rear of the Home position
sensor sub-assembly do not touch the Carriage motor.
Sub-assembly I
CONFIDENTIAL
To Next Page
Loading...
