108
Assign bearings to a group
To assign one or more bearings to a group proceed as follows:
Select the desired group from the Group list.
Search for one or more bearings as described at "Edit/change bearing ->
Search bearing ". The bearings found are displayed in the Unassigned
bearings list.
To assign a bearing to the group click on it then click on . The bearing
should now be displayed in the Assigned bearings list.
To assign all bearings found to the group, click on . All bearings should now
be displayed in the Assigned bearings list.
To delete a bearing from the group click on the bearing in the Assigned
bearings list then click on .
To delete all bearings from the group, click on .
Click on Save assign the bearings to the group in the bearing database.
Rename a group
To rename a group, select it from the Group list and click on .
Enter a new name for the group and click on OK.
Delete a group
To delete a group, select it from the Group list and click on .
Warning! the group is deleted immediately - you will not be
prompted to confirm this! You should therefore only use these
functions if you are sure that you want to delete a group.
4.6.6 Add manufacturer
Click on Add manufacturer to create a new manufacturer.
Enter the manufacturer's data in the appropriate input fields and click on Next.
Check your input in the next window that appears. If the input is correct, click
Add to save the manufacturer in the bearing database or click Back to
modify your input.
105
102
To Next Page
Loading...
