52
The first time the dongle is used Windows detects the driver that
was previously installed with the Trendline software. If Windows
asks for a driver, select the automatic search option.
If the dongle is not displayed or a previously used dongle
appears in the list, please click Refresh dongle list.
If the dongle is correctly identified by Windows but this is not
displayed in the Trendline dongle list you may have an old driver
installed on your system. You can check this in the device
manager under USB controller -> CBUSB Ver 2.0. If Version 1.x
is displayed, uninstall this driver and install the current driver on
the Trendline CD to the CbSetup directory. In this case select the
CRYPTO-BOX USB.
4.3.4 Register and configure new Detector
The Trendline software uses a database to manage all Detectors being used.
Prior to sending data to the Detector for the first time, it has to be registered to
Trendline software. To do that, you connect the Detector to a serial interface of
your computer using the data cable supplied and switch on the Detector.
The Detector that has just been connected to the computer is
normally detected automatically by the system and does not need
to be registered.
How to register a new Detector:
Click on Detector > Configure Detector.
To Next Page
Loading...
