FAG Detector III - Display and Icons; Switching on and off

214
* Space character
To edit entries, select the appropriate position using the cursor keys or and
overwrite the following positions.
6.1.2 Switching on and off
Switching on
Keep the on/off button pressed for one second to switch on the Detector. Right
after switching on, the system checks the accumulator charge level. If it is not
sufficient for a measuring process, i.e. of battery charge is less than 5% of
maximum capacity, you are prompted to recharge the accumulator. The Detector
shuts down after this error message.
If no new action is performed within a certain time after the Detector's last action,
the device automatically shuts down. You must switch it back on to perform a new
action. The power down time can be configured in the system menu .
If the accumulator is completely empty, you will not be able to
switch on the Detector at all (without an error message). This
prevents the accumulator from deep discharging. Recharge the
accumulator to work with the Detector again.
Switching off
Press the on/off button again to switch off the Detector.
6.1.3 Display and icons
All information necessary for operating the device is shown to the user on a
display. This includes
selection of measuring points,
user guidance while measuring,
display of measured values,
status display of data transfer between computer and Detector
and system settings.
220