109
Trendline 3
4.6.7 Edit / delete manufacturers
Edit manufacturer
Click on Edit manufacturer to modify the data for a manufacturer.
Modify the manufacturer data and click on Next.
In the next window the Trendline shows your changes and the original data for
an easy compare. Click on Save to store your changes in the bearing database
or click on Back to change your data.
Delete manufacturer
If you have deleted all bearings from a manufacturer from the bearing database
(see Edit/delete bearings ), you can also remove the manufacturer.
Click Delete manufacturer.
Then select the manufacture from the Manufacturer list and click Continue.
The manufacturer is then deleted from the bearing database.
You can only delete manufacturers which have been added by
yourself!
4.6.8 Select bearing database
Click in the Bearing database dialog on Change database.
Select the database as described in "Select database" . The name of the
included bearing database is "cm_bearings".
This opens the bearing database.
4.6.9 Close
To exit the bearing database
click Close.
4.7 Template and route planning
Constantly recurring plant structures and measurement tasks can be performed
efficiently with the help of templates and routes.
4.7.1 Template planning
A template has the same layout as a measuring point. As with a measuring point,
time signals can be recorded and different characteristic values set. If you want to
102
105
108
102
93
To Next Page
Loading...