FAG Detector III - Importing Data from a Trendline Database

142
Heading
Contents
Timestamp
Measurement timestamp.
export_timestamp
Export time
Measuring point from a run up/coast down configuration
If you export a Measuring point from a balancing configuration, the Trendline
software saves a file containing the values of the amplitude/phase diagram in
addition to a general export file with details of the configuration.
The general export file contains the following details:
Heading
Contents
id
Identification number
Run up / coast down
measuring point
Name of measuring point
timestamp
Measurement timestamp
Comment
Measurement comment
No. data points
Number of values measured in run up/coast down.
bodeplot data file
File with values from the amplitude/phase diagram
export timestamp
Export time
The file with the amplitude/phase diagram values contains the following details
for each diagram value:
Heading
Contents
Amplitude
Vibration amplitude
Phase
Phase of the vibration
Frequency
Rotational speed
4.15.3 Importing data from a Trendline database
You can import configurations and measurement data that have been exported
with the Export Wizard in the Trendline software.
Import data of Trendline software from version 3.2
Click on File > Import > Trendline data (.tr3).
137